Royal Sovereign Using Foot Pedal And Remote Control, Using Cross Cutter, RSH-1151/1651

9. USING FOOT PEDAL AND REMOTE CONTROL

USING FOOT PEDAL

Place the foot pedal on the floor in front of the machine.

Once all correct settings are displayed, you may use the foot pedal to operate the laminator for “Hands Free

Operation.” To activate the machine, press the foot pedal once and then release. Repeat to stop the rollers.

USING REMOTE CONTROL(OPTION) 1 2 3

Located on the left hand side of the rear of the laminator, to use press:

1.RUN : To activate the rollers.

2.STOP : To stop the rollers from turning.

3.REV : To reverse the rollers. Press and hold the button (useful for jams or mis-feeds of media).

10. USING CROSS CUTTER

The cross cutter is located in the rear exit table of the unit.

1. After lamination, move the cutter approximately to the center of the completed application at the desired point of detachment (Figure 1).

Figure 1

2. Grasp film with one hand, press the cutter

downward into the application and slide it first to one Figure 2 end of the application, then to the other end to

complete the cut (Figure 2 & 3).

Figure 3

9

RSH-1151/1651

11.USING SLITTER (OPTION)

1.Adjust the left and/or right slitters by loosening the

slitter adjuster knob (located between the front and rear rollers.) Figure 1

	Figure 1
2. Activate the slitter by turning the slitter knob(located
on the left side of the machine) counterclockwise.
Figure 2	Figure 2

3.Once you activate the slitter then you can begin lamination. Figure 3

	Figure 3
4. To deactivate the slitter turn the slitter knob
clockwise. Figure 4	Figure 4

NOTE: When the slitter becomes dull break off the blade. Pull the lock back,then pull the slitter out,and push the lock back to previous position. Figure 5

Figure 5

CAUTION

When the slitters are not in use please keep the slitters positioned at the far left and right side to avoid injury.

10