13.3 Mounting
1. Lay the decaled image face down on a flat surface. |
Carefully peel back and put a crease along the edge of |
the release liner (Approximately 1 in or 25mm, Figure 1). |
14.INSTALLATION OF FRONT FEEDER and REAR REWINDER OPTIONS
Figure 1
2.With the image facing up, align the image onto the board. Press firmly from the center out (Figure 2).
Figure 2
Note : Below options are to be installed by an authorized RS reseller.
Installation of the Front Feeder Option (Includes 2 brackets, one spindle, and mounting hardware).
1.Install the Front Feeder to the inside of the front frames using four 1/4" (M6) hexagon bolts on each side (Figure 1)
Installing the Rear Rewinder Option (Includes motorized winder, bracket, one spindle, and mounting hardware).
1.Remove the left and right covers by using a screwdriver (four screws on each side cover) (Figure 2 & 3).
Figure 1
Figure 2 | Figure 3 |
3.Adjust the pressure lever to ensure the proper opening (Figure 3).
Figure 3
4.Flip the image over the upper roller and hold on to the release liner (Figure 4).
5. Depress the foot pedal once, and then let it go while | Figure 4 |
| |
slowly pulling the release liner as the board enters the |
|
main roller nip (Figure 5). |
|
Depress the foot pedal once again when the board has |
|
completely exited from the rear of the unit. |
|
Trim the board if necessary. |
|
| Figure 5 |
15
2. Remove the lever knob screw and lever (Figure 4).
3. | Remove the rear cover by removing all | Figure 4 |
| ||
| 10 screws (4 top, 4 bottom, and 1 on |
|
| each side) (Figure 5 & 6). |
|
| Figure 5 | Figure 6 |
4. | Disassemble the power switch bracket and place the left |
|
| rewinder outside of the frame; fasten with round head |
|
| 3/16"(M5) screws (included in the option kit). Then, reinstall |
|
| the power switch bracket (Figure 7). |
|
5. | Install the right rewinder on the outside of the frame and |
|
| connect the motor wire connector to the rear wire | Figure 7 |
| (Figure 8 & 9). | |
|
|
6.Reinstall the rear cover.
7.Reinstall the side covers.
8.Reinstall the lever knob and screw.
Figure 8 | Figure 9 |
16
