Runco VX-55D, VX-44D operation manual Input Names

Operation

Input Names: You can give each DHD Controller input a descriptive name. For example, you may want to change the default input name to the type of source component connected to it: “VCR,” “DVD,” “Laptop” et cetera. Input names can be up to 12 characters long.

To edit an input name, select Input Names from the Service menu. Press or to select an input and press ENTER. Use the or buttons to change a character; press

or to select a character to change. When you have finished editing the input name, press ENTER or MENU.

To restore the default input name, press repeatedly to highlight that input name in the “Restore” column. Then, press ENTER.

Remote Control: Select Remote Control from the Service menu to change the following settings related to remote control operation.

•Remote Code: Select Remote Code from the Remote Control menu to set the infrared (IR) code set to which the DHD Controller will respond. By default, it is set to

17. You can change this setting if either:

•Another device in the theater (a DVD player, for example) is responding to commands from the DHD Controller remote control (Figure 2-6)in ways that are unpredictable or undesirable.

•You have multiple DHD Controllers and want to control them independently, as opposed to broadcasting commands from a single remote to all of them. In this scenario, you can use multiple remotes programmed to use different IR codes. Or, you can use a single remote and change the IR code as needed to address a specific DHD Controller.

Use the DHD Controller front-panel keypad to change the IR code to

Tip which the controller will respond. Then, change the code sent by the remote to match as described below.

When you change a remote code on the DHD Controller, you must re-program the DHD Controller remote control to send that same code. To do this:

1. Press and hold the LIGHT button on the remote control for approximately three

seconds, or until the LED on the remote lights	RETURN
	EXIT
solid red.

2.Enter a new two-digit code between 00 and 31 inclusive. Include a leading zero for single-digit codes; for example, enter 9 as “09.”

3.The LED turns off to confirm the code change. If you enter an invalid code, the LED flashes for three or four seconds. Try again, entering a valid code.

•COMP Key Source: Select COMP Key Source from the Remote Control menu to assign the COMP remote control button to either the Component or SCART input.

					Input Names
							Restore
C	o	m p o s i				t e	Composite
S	- V i d e o					1	S-Video 1
S	-	V i d e o				2	S-Video 2
C	o	m p		o n e n t			Component
H	D	1					HD 1
H	D	2					HD 2
S	C	A	R	T			SCART
H	D	M	I		1		HDMI 1
H	D	M	I		2		HDMI 2

Runco VX-44d/-55d Installation/Operation Manual 71