Russell Hobbs RHDW1 instruction manual Failure Codes and What to do in Case of Failure

FAILURE CODES AND WHAT TO DO IN CASE OF FAILURE

ERROR CODE			ERROR	CONTROL
Wash /Dry	End	Start/Pause	DESCRIPTION
			Inadequate water	•	Make sure the water input tap is totally open and that
					there is no water cut.
			supply
				•	Close the water input tap, separate the water input
					hose from the tap and clean the filter at the connection
					end of the hose.
				•	Restart your machine, contact the service if the error
					resumes.
			Error of continuous	•	Close the tap.
				•	Contact the service.
			water input
			The waste water in the	•	Water discharge hose is clogged.
				•	The filters of your machine might be clogged.
			machine cannot be
			discharged.	•	Power off-on your machine and activate the program
					cancellation command.
			Intended water	•	If the error continues, contact the service.
			temperature could not	Contact the service.
			be reached faulty
			heater and heater
			sensor
			Alarm is active against	•	Power off your machine and close the tap.
			water overflow
				•	Contact the service.

Faulty electronic card

Contact the service.

If one of program monitor lights is on and the start/Pause light flashes on and off, Your machine’s door is open, shut the door.

If the programme won’t start

•Check if the plug is connected.

•Check your indoor fuses.

•Be sure that the water inlet tap is turned on.

•Be sure that you have closed the machine door.

•Be sure that you switched off the machine by pressing the Power On / Off button.

•Be sure that the water inlet filter and the machine filters are not clogged.

If the “Wash/Dry” and “End” lights keep flashing

•Water overflow alarm is active

•Turn off your tap and contact an authorised service.

If the control light won’t go out after a wash operation

The Power On/Off button is released yet.

If detergent residues are left in the detergent compartment Detergent has been added when the detergent compartment was wet.

25