Ryobi 105r, 132r, 137r Maintenance and Repair Instructions, Line Installation for Speedspool

MAINTENANCE AND REPAIR INSTRUCTIONS

LINE INSTALLATION FOR THE

SPEEDSPOOL®

The trimming line in the speed spool may be replaced by two different methods.

•Winding the existing inner reel with new line

•Installing a prewound inner reel

THE CORRECT LINE TO USE

WARNING: Always use genuine Monoflail® replacement line. Do not use metal-reinforced line.

It is very important to use the correct size line. Line with a diameter of 0.60 in (1.52 mm) must be used on Model 105r; 0.080 in (2.03 mm) for Models 132r and 137r. The motor may overheat and fail if you use a larger line.

TO INSTALL NEW TRIMMING LINE, IT IS NOT NECESSARY TO REMOVE THE BUMP KNOB.

Winding the existing inner reel with new line

NOTE: Before installing new trimming line onto the existing inner reel, remove any old line from the SpeedSpool by pulling the line out of the line loading or locking holes (See Figs. 18 and 19 for location of holes).

1.Line up the arrow on the inner reel with the arrow on the outer spool (Fig. 17).

TOP VIEW OF THE SPEEDSPOOL

Outer	Arrow
Spool

Inner

ReelBump

Knob

Fig. 17

NOTE: Do not wind the inner reel before the second line is installed into the reel.

WARNING: Always use the correct line length when installing trimming line on the unit. If longer line is used than specified in this manual, the line may not release properly.

2.Insert 10 feet (2.5 m) for models with .080 in (2.03 mm) of trimming line and 15 ft (4.5 m) for models with .060 in (1.52 mm) line into one of the two eyelets and push it up through the line loading hole in the inner reel (Fig. 18). Do not bend the line when inserting it into the eyelet.

Trimming Line

Eyelet

Line Loading Hole

Fig. 18

3.Insert the line into the locking hole (Fig. 19) no more than 1/2 inch (12.7 mm). Do not push the line too far into the inner reel. A small loop is formed when the line is inserted correctly (Fig. 19).

Locking Hole

Fig. 19

11