![](/images/new-backgrounds/1123077/12307727x1.webp)
MAINTENANCE AND
REPAIR INSTRUCTIONS
CLEANING THE TRIMMER
WARNING: To avoid serious personal injury, always unplug your unit before you clean or perform any maintenance on it.
1.Use a small brush or the air discharge of a vacuum cleaner brush to clean the fan blades.
2.Keep the air vents free of obstructions.
3.Do not use any strong detergents on the plastic housing or handle. They can be damaged by certain household cleaners that contain aromatic oils such as pine and lemon, and by solvents such as kerosene. Moisture can also cause a shock hazard. Wipe off any moisture with a soft cloth.
SPECIFICATIONS
MOTOR
Motor type . . . . . . . . . . . . . . . . . . . . . . . . . Electric Operating RPM . . . . . . . . . . . . . .
DRIVE SHAFT AND CUTTING HEAD
Drive Shaft . . . . . . . . . . . . . . . . . . . 1/4 in (6.5 mm) Shoulder Strap . . . . . . . . . . . . . . . . . . . . . Optional Cutting Head . . . . . . . . . . . . . Bump Line Releaser Cutting Path Diameter . . . . . . . . . . 15 in (381 mm) Drive Shaft Housing . . . . . Steel Tube - Model 105r
Steel Tube,
Models 132r and 137r Trimming Line Diameter . . . . . . 0.060 in (1.52 mm), Model 105r 0.080 in (2.03 mm),
Models 132r and 137r
TROUBLESHOOTING
PROBLEM | CAUSE | REMEDY |
|
|
|
Motor Will Not Start | Motor stops, unit unplugged | Check cord to see if it is plugged |
|
| into an electrical outlet |
|
|
|
Cutting Head Will Not Turn | Cutting head bound with grass | Stop motor and clean cutting |
When Trigger is Squeezed | or debris | head |
|
|
|
Cutting Head Will Not | Cutting head out of line | Refill with genuine replacement |
Advance Line |
| cutting line |
| Inner reel bound up | Replace inner reel |
| Cutting head dirty | Clean cutting head reel/spool |
| Indexing teeth worn or burred | Replace reel and spool |
| Line welded | Disassemble, remove the welded |
|
| section, and rewind the line |
| Line twisted when refilled | Disassemble cutting head and |
|
| rewind the inner reel |
| Not enough line exposed | Push the Bump Knob and pull |
|
| out the line until a minimum of |
|
| 4 in (102 mm) is outside of |
|
| cutting head |
|
|
|
14