Ryobi 130rEB Assembly Instructions, Adjusting The D-Handle, Installing Cutting Attachment Shield

ASSEMBLY INSTRUCTIONS

ADJUSTING THE D-HANDLE

1. Hold the unit in the operating position (Fig. 1).

Fig. 1

2.Loosen the wing nut (Fig. 2). It is not necessary to remove the wing nut, washer or bolt.

3.Position the D-handle to the location that provides you the best grip, and tighten the wing nut (Fig. 2).

INSTALLING CUTTING ATTACHMENT SHIELD

WARNING: To avoid injury, never operate the trimmer without the cutting attachment shield installed. If the trimmer is operated without it in place, you will VOID the warranty.

1.Place the cutting attachment shield onto the shaft housing above the clamp assembly (Fig. 3).

2.Push the cutting attachment shield down to the top of the cutting attachment assembly and then rotate the cutting attachment shield 180°. Align the 4 screw holes and fit the cutting attachment shield securely in the recessed pocket (Fig. 3).

3.Install the four (4) screws (10-24 x 1/2) with a regular Phillips screwdriver (Fig. 4). Tighten securely.

Shaft Housing

Clamp

Assembly

Cutting	Cutting
	Attachment
Attachment
	Shield

Fig. 3

Screws

D Handle

Wing Nut

Fig. 2

Fig. 4

8