Ryobi 130rEB manual Operating Instructions, Operating The Click-Link System

OPERATING INSTRUCTIONS

OPERATING THE CLICK-LINK® SYSTEM

The Click-Link® system enables the use of these optional add-ons.

Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r Hedge Trimmer (gas units only) . . . . . . . . . . . . . HS720r Snow Thrower (gas units only) . . . . . . . . . . . . . . ST720r Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . SS725r Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TP720r Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r

WARNING: Read and understand operator’s manual for add-on prior to operation.

Removing the Cutting Attachment or Add-Ons:

1.Turn the knob counterclockwise to loosen (Fig. 7).

2.Press and hold the release button (Fig. 7).

3.While firmly holding the upper shaft housing, pull the cutting attachment or add-on straight out of the Click-Link® coupler.

Installing the Cutting Attachment or Add-Ons:

WARNING: To avoid serious personal injury, shut unit off before removing or installing add-ons.

NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench.

1. Turn the knob counterclockwise to loosen (Fig. 7).

Click-Link®Coupler Release Button

Guide

Knob Recess

Fig. 7

2.While firmly holding the add-on, push it straight into the Click-Link® coupler (Fig. 8).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 8).

Click-Link®Coupler Release Button

Primary Hole

Upper Shaft		Lower Shaft
Housing
		Housing
	Fig. 8

3. Turn the knob clockwise to tighten (Fig. 9).

CAUTION: Lock the release button in the primary hole and securely tighten the knob before operating this unit.

90˚ Edging Hole

180˚ Edging

Hole

Knob

Fig. 9

CAUTION: The cutting attachment and add- ons with the Click-Link® system are to be used in the primary hole unless stated other- wise in the specific add-ons operator’s man- ual. Using the wrong hole could lead to per- sonal injury, or damage to the unit.

For edging when using the line head cutting attachment with Click-Link® models, lock the release button of the cutting attachment into the 90° edging hole or the 180° edging hole(Fig. 9). The edger add-on should be installed with the release button in the primary hole.

10