Direct Paging - Handsfree Answerback Disabled

Your administrator enables or disables Handsfree Answerback and you can also turn it on or off on your phone.

To turn Handsfree Answerback off, see "Direct Paging – Handsfree Answerback Enabled" elsewhere in this guide. When Handsfree Answerback is disabled on your phone and you receive a Direct Page, the Direct Page is indicated by a single burst of tone.

To answer Direct Page calls when Handsfree Answerback is disabled:

Phone state before Page

To answer the Direct Page (indicated by single burst of tone):

arrives:

 

Phone is idle and MUTE is OFF.

1.Check that MUTE is ON solid. 2. Lift the handset OR press MUTE key to answer in Handsfree mode. (The light turns OFF.)

3.Begin speaking.

You are on a handset call or headset call, and MUTE is

OFF

1.Check that MUTE is flashing. 2. Press MUTE. The light turns ON solid and and you are now speaking to the paging party and have MUTED your handset/headset call. 3. Speak to the paging party. Press MUTE to alternate between handset and handsfree calls.

You are on a MUTED The party paging you receives a busy tone. Handsfree Answerback handset/headset call, OR, you does not interrupt your call.

are on a Handsfree call

To end a Direct Page call, do one of the following:

Hang up the handset to end a handset call.

Press ( SPEAKER ) to end a Handsfree call.

Press ( CANCEL ).

Note: When the Handsfree Direct Page call ends, the (MUTE) key light returns to the state it was in before the call was established.

Reminder (5224 IP Phone only)

To program a Reminder:

1.Press ( SUPERKEY ).

2.Press the No softkey until "Timed Reminder?" appears.

3.Press the Yes softkey.

32

Page 38
Image 38
NEC manual Direct Paging Handsfree Answerback Disabled, Reminder 5224 IP Phone only