Ryobi CH120L Save These Instructions, One World Technologies, Inc, Charging A Hot Battery Pack

Models: 130503001

1 6
Download 6 pages 22.97 Kb
Page 2
Image 2
CHARGING A HOT BATTERY PACK

Do not place the charger and battery pack in an area of extreme heat or cold. They will work best at normal room temperature.

Note: The charger and battery pack should be placed in a location where the temperature is more than 50°F but less than 100°F.

When batteries become fully charged, unplug the charger from the power supply and remove the battery pack.

To remove the battery pack from the charger, depress the latches on each side of the battery pack.

CHARGING A HOT BATTERY PACK

When using a tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge.

Note: This situation only occurs when continuous use of a tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to CHARGING A COOL BATTERY PACK for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorized Service Center for electrical check.

BATTERIES

These batteries have been designed to provide maximum trouble-free life. However, like all batteries, they will even- tually wear out. Do not disassemble battery pack and at- tempt to replace the batteries. Handling of these batteries, especially when wearing rings and jewelry, could result in a serious burn.

To obtain the longest possible battery life, we suggest the following:

Remove the battery pack from the charger once it is fully charged and ready for use.

For battery pack storage longer than 30 days:

Store the battery pack where the temperature is below 80°F and away from moisture.

Store battery packs in a 30%-50% charged condition.

Every six months of storage, charge the pack as normal.

BATTERY PACK REMOVAL AND

PREPARATION FOR RECYCLING

To preserve natural resources, please recycle or dispose of batteries ­properly.

 

This product contains lithium-ion

Li - Ion

batteries. Local, state or federal laws

may prohibit disposal of lithium-ion

 

 

batteries in ordinary trash.

Consult your local waste authority for information regarding available recycling and/or disposal options.

WARNING:

Upon removal, cover the battery pack’s terminals with heavy-duty adhesive tape. Do not attempt to destroy or disassemble battery pack or remove any of its compo- nents. Lithium-ion batteries must be recycled or disposed of properly. Also, never touch both terminals with metal objects and/or body parts as short circuit may result. Keep away from children. Failure to comply with these warnings could result in fire and/or serious injury.

Ryobi® is a registered trademark of Ryobi Limited used under license.

ONE WORLD TECHNOLOGIES, INC.

1428 Pearman Dairy Road

Anderson, SC 29625

Phone 1-800-525-2579

www.ryobitools.com

SAVE THESE INSTRUCTIONS

987000-241

07-25-08 (REV:03)

Page 2
Image 2
Ryobi CH120L, 140503001 manual Save These Instructions, One World Technologies, Inc, Charging A Hot Battery Pack, Batteries