Ryobi 2075RC Fig, Fig, Fig, Fig, line, Bump, Reel, Knob, NOTE:, Inner, NOTE:, Eyelet, WARNING:, WARNING:, Do not use, SPEEDSPOOL®, Locking Hole, Trimming Line

MAINTENANCE AND REPAIR INSTRUCTIONS

LINE INSTALLATION FOR THESPEEDSPOOL®

The trimming line in the speed spool may be replaced by two different methods.

•Winding the existing inner reel with new line

•Installing a prewound inner reel

TO INSTALL NEW TRIMMING LINE, IT IS NOT NECESSARY TO REMOVE THE BUMP KNOB.The Correct Line to Use

WARNING: Always use genuine Ryobi replacement line. Do not use metal-reinforced line.

It is very important to use the correct size line.

Use line with a diameter of 0.080 in (2.03 mm). The motor may overheat and fail if you use a larger line.

WINDING THE EXISTING INNER REEL WITH NEW LINE

NOTE: Before installing new trimming line onto the existing inner reel, remove any old line from the SpeedSpool by pulling the line out of the line loading or locking holes (Figs. 11 and 12).

1.Line up the arrow on the inner reel with the arrow on the outer spool (Fig. 10).

WARNING: Always use the correct line length when installing trimming line on the unit. If longer line is used than specified in this manual, the line may not release properly.

TOP VIEW OF THE SPEEDSPOOLOuter Arrow Spool

Inner	Bump
Reel
	Knob

Fig. 10

NOTE: Do not wind the inner reel before the second line is installed into the reel.

2.Insert 10 feet (2.5 m) of .080 in (2.03 mm) trimming line into one of the two eyelets and push it up through the line loading hole in the inner reel (Fig. 11). Do not bend the line when inserting it into the eyelet.

Trimming LineEyeletLine Loading Hole

Fig. 11

3.Insert the line into the locking hole (Fig. 12) no more than 1/2 inch (12.7 mm). Do not push the line too far into the inner reel. A small loop is formed when the line is inserted correctly (Fig. 12).

Locking Hole

Fig. 12

4.Pull the line away from the spool until the line is tight against the inner reel (Fig. 13).

Fig. 13

11