Ryobi 2075RC STARTING/STOPPING, OPERATING INSTRUCTIONS, Fig, (A), Run, (B), Fig, Fig, Bulb, Choke, Lever, Start, NOTE:, NOTE:, NOTE:, Switch, Primer, WARNING:, WARNING:

OPERATING INSTRUCTIONS

STARTING/STOPPING

WARNING: Operate this unit only in a well-ventilated area outdoors. Carbon monoxide exhaust fumes can be lethal in a confined area.

WARNING: Avoid accidental starting. Be in the starting position whenever pulling the starting rope. To avoid serious personal injury, the operator and unit must be in a stable position while starting.

1.	MIX OIL WITH GAS AND FILL FUEL TANK
	WITH FUEL/OIL MIXTURE per instructions
	on page 8.
2.	Put the IGNITION SWITCH IN THE “ON”
	POSITION (Fig. 5).
3.	FULLY PRESS AND RELEASE THE PRIMER
	BULB 5 TO 7 TIMES. FUEL SHOULD BE

10.To stop the engine, put the IGNITION SWITCH

IN THE "OFF" POSITION (Fig. 5).

Ignition

Switch

Fig. 5

Choke

Lever

Start

VISIBLE IN THE BULB (Fig. 6).

4. PLACE THE CHOKE LEVER IN THE

“START” POSITION (A) (Fig. 6).

(A)

Run

(B)

5. WITH THE UNIT ON THE GROUND,

SQUEEZE THE THROTTLE TRIGGER

FULLY AND PULL THE STARTER ROPE

BRISKLY (Fig. 7) until the engine sounds like

it wants to run (normally 2 to 5 pulls).

NOTE: Keep the throttle trigger depressed at all times until the engine is warmed up.

6.PLACE THE CHOKE LEVER IN THE “RUN” POSITION (B) (Fig. 6).

7.PULL THE STARTER ROPE BRISKLY 1 TO 3 TIMES TO START THE ENGINE (Fig. 7).

8.If the engine does not start, repeat steps 4 through 7.

NOTE: If the engine floods while attempting to start the unit, place the choke lever in the “RUN” position (B), squeeze the throttle trigger, and pull the starter rope briskly. The engine should start within three (3) to eight (8) pulls.

9.Keep throttle trigger depressed for 5 to 10 seconds to warm up engine.

NOTE: Choking is not required when starting a warm engine. Start a warm engine in the “RUN” POSITION.

Primer

Bulb

Fig. 6

Fig. 7

9