TOOLS NEEDED

7/16 in. NUT DRIVER

3/16 in. HEX KEY

Fig. 2

ASSEMBLY

WARNING:

The table saw should never be connected to a power supply while you are assembling parts. Disconnect- ing the table saw will prevent accidental starting that could cause serious personal injury.

INSTALLING THE MITER SLOT TABLE

See Figure 3.

Turn the ON/OFF switch to the OFF position.

Unplug the saw from the switched on-board outlet.

Disconnect the saw from the power supply.

Remove the sliding miter table and accessory table from the saw.

Place the miter slot table onto the saw as shown in Figure 3.

1/4-20 x 1 in.

MITERHEX CAP SCREW SLOT TABLE

SHIMS

WASHER

1/4-20 NUT

Fig. 3

4

Page 4
Image 4
Ryobi 4060310 manual Tools Needed, Assembly, Installing the Miter Slot Table, Miterhex CAP Screw Slot Table Shims Washer