Ryobi 4060310 Aligning the Miter Slot Table, Rear View Miter Slot Table, HEX CAP Screw Washer

ASSEMBLY

REAR VIEW

MITER

SLOT TABLE

1/4-20 x 1 in.

HEX CAP SCREW

PLACE SHIMS

AS SHOWN

SHIMS

FRONT VIEW

ALIGNING THE MITER SLOT TABLE

See Figure 4.

■Place the miter slot table on the saw as shown in Figure 4.

■Extend a straight edge across the saw table onto the miter slot table and note any space between the straight edge and the miter slot table. If space ex- ists, place one of the shims under the miter slot table and recheck. Add shims as required between the miter slot table and the saw table to allow the miter slot table to be flush with or slightly lower than the saw table. Repeat the process for the rear of the miter slot table. Recheck in front and rear to assure that the miter slot table is not above the surface of the saw table.

■Place mounting bolts with washers through holes in the miter slot table and the saw table frame as shown in Figure 5. Place a nut under the lip of the saw frame on each bolt. Tighten firmly and evenly. Shims will be secured when you tighten the screws.

■Replace the sliding miter table and the accessory table.

NOTE: The miter slot table must not be higher than the saw table.

1/4-20 x 1 in.

HEX CAP SCREW

WASHER

1/4-20 NUT

WASHER

1/4-20 NUT

Fig. 4

MITER

SLOT TABLE

SHIM

Fig. 5

5