ASSEMBLY INSTRUCTIONS

INSTALLING THE CUTTING

ATTACHMENT SHIELD

Use the following instructions if the cutting attachment shield on your unit is not installed.

WARNING: Never operate the trimmer without the cutting attachment shield in place to prevent serious personal injury.

1.Slide the cutting attachment shield into the shield mount on the cutting attachment. Align the screw holes in the shield with the holes in the cutting attachment (Fig. 4).

Shaft Housing

Cutting Attachment

Shield

 

Shield Mount

Cutting Attachment

Fig. 4

2.Place a hex lock nut into one of the three recessed holes on the top of the cutting attachment shield (Fig 5).

Cutting Attachment

Shield

Recessed Holes Hex Lock Nut

3.Install a screw into the hole from the bottom of the cutting attachment shield and screw it into the nut installed in step #2 (Fig 6). Do not tighten.

Screws

Fig. 6

4.Repeat steps 2 and 3 until all three screws have been started, then tighten screws securely with a Phillips head screwdriver.

Fig. 5

10

Page 10
Image 10
Ryobi 766r manual Installing the Cutting Attachment Shield, Shield Mount Cutting Attachment, Screws