ASSEMBLY INSTRUCTIONS
INSTALLING AND ADJUSTING THE J-HANDLE
1.Place the
(4) Screws
Top Clamp
Middle Clamp
Bottom Clamp
Nuts
Fig. 1
2.While holding the three pieces together, install the four (4) screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up only when assembled correctly.
3.Place the clamps and
4.Hold each hex nut in the bottom clamp recess with a finger. Start screws with a large Phillips screwdriver. Do not tighten until you make the handle adjustment.
5.Slide the
Decal
Fig. 2
6.While holding the unit in the operating position (Fig. 3), position the
7.Tighten the clamp screws evenly, until the
INSTALLING THE CUTTING ATTACHMENT SHIELD
Use the following instructions if the cutting attachment shield on your unit is not installed.
WARNING: Never operate the trimmer without the cutting attachment shield in place to prevent serious personal injury.
1.Slide the cutting attachment shield into the shield mount on the cutting attachment. Align the screw holes in the shield with the holes in the cutting attachment (Fig. 4).
Shaft Housing
Cutting Attachment
Shield
Shield Mount
Cutting Attachment
Fig. 4
2.Place a hex lock nut into one of the three recessed holes on the top of the cutting attachment shield (Fig 5).
Cutting Attachment
Shield
Recessed Holes
Hex Lock Nut
Fig. 5
Fig. 3
8