ASSEMBLY INSTRUCTIONS
INSTALLING AND ADJUSTING THE J-HANDLE
1.Place the
J-Handle
(4) Screws
Top Clamp
Middle Clamp
Bottom Clamp
Nuts
Fig. 1
2.While holding the three pieces together, install the four (4) screws through the top clamp and into middle clamp.
NOTE: The holes in the top and middle clamp will line up only when assembled correctly.
3.Place the clamps and
4.Hold each hex nut in the bottom clamp recess with a finger. Start screws with a large Phillips screwdriver. Do not tighten until you make the handle adjustment.
5.Slide the
6.While holding the unit in the operating position (Fig. 3), position the
Fig. 3
7.Tighten the clamp screws evenly, until the
Decal
Fig. 2
10