ASSEMBLY INSTRUCTIONS
5.Make sure that the cutting blade is centered on the pilot step and sitting flat against the output shaft bushing (Fig. 12).
WARNING: If the cutting blade is
Pilot Step
Fig. 12
6.Align the shaft bushing hole with the locking rod slot and insert the locking rod into the bushing hole (Fig. 8).
7.Put the blade retainer and nut on the output shaft. Make sure that the blade is installed correctly.
8.Tighten counterclockwise against the blade while holding the locking rod (Fig. 13).
Counterclockwise
Fig. 13
•If using a torque wrench and an 5/8 inch socket tighten to;
325 - 335 in•lb,
27 - 28 ft.•lb,
37
•Without a torque wrench, use a 5/8 inch
1/4-1/2 turn
Counterclockwise
Fig. 14
9.Remove the locking rod from the locking rod slot.
WARNING: To avoid serious personal injury or damage to the unit, do not start or operate this unit with the locking rod in the locking rod slot.
10.Remove the cutting blade cover by
WARNING: Do not sharpen the cutting blade. Sharpening the blade can cause the blade tip to break off while in use. This can result in severe personal injury. Replace the blade.
NOTE: A replacement cutting blade,
Part # 145873 can be purchased from you local authorized dealer.
13