Ryobi 825r manual Operating Instructions, Operating the CLICK-LINKSYSTEM

OPERATING INSTRUCTIONS

OPERATING THE CLICK-LINK®SYSTEM

The Click-Link®system enables the use of these optional add-ons.

Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . BV720r Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . GC720r

2.While firmly holding the add-on, push it straight into the Click-Link®coupler (Fig. 12).

NOTE: Aligning the release button with the guide recess will help installation (Fig. 11).

Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . LE720r

Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . HS720r

Snow Thrower . . . . . . . . . . . . . . . . . . . . . . . . . . . ST720r

Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . SS725r

Sweeper/Blower . . . . . . . . . . . . . . . . . . . . . . . . . SB720r

Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TP720r

Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TB720r

Click-Link®Coupler

Release Button

Primary Hole

WARNING: Read and understand operator’s manual for add-on prior to operation.

Removing the Cutting Attachment or Add-Ons:

1.Turn the knob counterclockwise to loosen (Fig. 11).

2.Press and hold the release button (Fig. 11).

3.While firmly holding the upper shaft housing, pull the

cutting attachment or add-on straight out of the Click-Link®coupler (Fig. 12).

Installing the Cutting Attachment or Add-Ons:

WARNING: To avoid serious personal injury and damage to the unit, shut unit off before removing or installing add-ons.

NOTE: To make installing or removing the add-on easier, place the unit on the ground or on a work bench.

1. Turn knob counterclockwise to loosen (Fig.11).

Click-Link® Coupler Release Button

Knob

Guide Recess

Fig. 11

Upper Shaft Housing

Lower Shaft Housing

Fig. 12

3. Turn the knob clockwise to tighten (Fig. 13).

CAUTION: Lock the release button in the primary hole and securely tighten the knob before operating this unit.

90˚ Edging Hole

180˚ Edging Hole

Knob

Fig. 13

CAUTION: The cutting attachment and add-ons with the Click-Link® system are to be used in the primary hole unless stated otherwise in the specific add-ons operator’s manual. Using the wrong hole could lead to personal injury, or damage to the unit.

For edging when using the line head cutting attachment with Click-Link® models, lock the release button of the cutting attachment into the 90° edging hole or the 180° edging hole(Fig. 12).

13