OPERATION
WARNING:
Do not allow familiarity with tools to make you care- less. Remember that a careless fraction of a second is sufficient to inflict serious injury.
WARNING:
Always wear safety goggles or safety glasses with side shields when operating power tools. Failure to do so could result in objects being thrown into your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
Grinding metals
Sanding wood or metal surfaces
SLIDE SWITCH
See Figure 3.
To turn the angle grinder ON, press the slide switch forward. To the lock the grinder in the ON position, depress front of switch To turn it OFF, push slide switch forward.
CAUTION:
Never cover air vents. They must always be open for proper motor cooling.
INSTALLING ACCESSORY WHEELS
See Figure 4.
Unplug the angle grinder.
Depress and hold the spindle lock button and rotate nut with provided wrench until spindle locks.
NOTE: To prevent damage to the spindle or spindle lock, always allow motor to come to a complete stop before engaging spindle lock.
Loosen and remove flange nut from spindle. Do not remove disc flange.
Make sure flats on the bottom of disc flange are engaged with flats on spindle.
Place the accessory wheel over the spindle.
SLIDE |
|
SWITCH | Fig. 3 |
WARNING:
Always install grinding wheel and abrasive mop disc with the depressed center against the disc flange as shown on the opposite page. Failure to do so will cause the grinding wheel to crack when tightening the clamp nut. This could result in serious personal injury because of loose particles breaking off and being thrown from the angle grinder. Do not overtighten.
Thread the flange nut on the spindle with the flat side of nut facing up. Fit raised, small diameter portion of the clamp nut into the hole in the wheel and finger tighten.
To install abrasive mop disc, thread the nut on the spindle with the flat side of flange nut facing down. Finger tighten.
Depress and hold the spindle lock button and rotate the wheel clockwise until the spindle locks in position.
Securely tighten the nut with the wrench provided. Do not overtighten.
DANGER:
Never attach a wood cutting or carving blade of any type to this angle grinder. It is only designed for grinding and sanding. Use for any other purpose is not recommended and creates a hazard, which will result in serious injury.
10
