ASSEMBLY
Align the screw holes in the saw table with the holes in the saw table bracket.
Using the phillips screws, attach the saw table to the saw table bracket. Tighten phillips screws securely.
Attach the table aligning bolt, washer, and wing nut to the saw table.
NOTE: The wing nut goes below the saw table.
SQUARING THE SAW TABLE TO THE BLADE
See Figure 8.
WARNING:
Failure to turn the saw off, remove the switch key, and unplug the saw could result in accidental starting causing possible serious personal injury.
Turn the lock knob counterclockwise to unlock the blade guide assembly. Turning the blade guide knob clockwise, raise the blade guide assembly as far as it will go. Turn the lock knob clockwise to retighten.
Place a small combination square on the saw table beside the blade.
Loosen the table lock knob and rotate the angle
adjustment knob to tilt the saw table up or down to align table 90° to blade (0° position). Retighten the table lock knob.
Using a hex key, adjust the zero stop set screw until the set screw just touches the saw housing.
Check squareness of the saw table to the blade. Make readjustments if necessary.
Loosen screw on scale indicator with a phillips screwdriver and align scale indicator to zero.
Tighten all screws securely.
LOCK
KNOB
TABLE ALIGNING
BOLT
BLADE GUIDE KNOB
WASHER 
WING
NUT
Fig. 7
ZERO STOP | BLADE | |
GUARD | ||
SET SCREW | ||
|
SAW
BLADESMALL COMBINATION
SQUARE
Fig. 8
Page 12
