Ryobi BGH825 Unpacking, Extension Cords, Electrical Connection, Grounding Instructions

ELECTRICAL

EXTENSION CORDS

Use only 3-wire extension cords that have 3-prong ground- ing plugs and 3-pole receptacles that accept the tool's plug. When using a power tool at a considerable distance from the power source, use an extension cord heavy enough to carry the current that the tool will draw. An undersized extension cord will cause a drop in line voltage, resulting in a loss of power and causing the motor to overheat. Use the chart provided below to determine the minimum wire size required in an extension cord. Only round jacketed cords listed by Underwriter's Laboratories (UL) should be used.

Length of Extension Cord	Wire Size (A.W.G.)
Up to 25 feet	16
26-50 feet	16
51-100 feet	16

When working with the tool outdoors, use an extension cord that is designed for outside use. This is indicated by the letters WA on the cord's jacket.

Before using an extension cord, inspect it for loose or exposed wires and cut or worn insulation.

GROUNDING

PIN

COVER OF GROUNDED

OUTLET BOX

Fig. 1

ELECTRICAL CONNECTION

Your Ryobi Bench Grinder is powered by a precision built electric motor. It should be connected to a power supply that is 120 volts, 60Hz, AC only (normal household current). Do not operate this tool on direct current (DC). A substantial voltage drop will cause a loss of power and the motor will overheat. If the machine does not operate when plugged into an outlet, double check the power supply.

CAUTION:

Keep the cord away from the grinding area and position the cord so that it will not be caught on material, tools, or other objects.

GROUNDING INSTRUCTIONS

In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This tool is equipped with an electric cord having an equipment-grounding conduc- tor and a grounding plug. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance with all local codes and ordinances.

Do not modify the plug provided. If it will not fit the outlet, have the proper outlet installed by a qualified electrician. Improper connection of the equipment-grounding conductor can result in electrical shock. The conductor with insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding conductor. If repair or replacement of the electric cord or plug is necessary, do not connect the equipment-grounding conductor to a live terminal.

Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or if in doubt as to whether the tool is properly grounded.

Repair or replace a damaged or worn cord immediately.

This tool is intended for use on a circuit that has an outlet like the one shown in figure 1. It also has a grounding pin like the one shown.

UNPACKING

n Carefully remove all parts from the shipping carton.	n If any parts are damaged or missing, do not attempt to
n Lift the bench grinder from the carton and place it on a	plug in this tool or turn it on until the damaged or missing
	parts are obtained and installed correctly.
level work surface.
n Do not discard the packing materials until you have care-	n Contact your nearest Ryobi dealer or call 1-800-525-2579
	in the United States or 1-800-265-6778 in Canada for
fully inspected the machine, identified all loose parts, and
	assistance if any parts are missing or damaged.
satisfactorily operated your bench grinder.
n Examine all parts to make sure no breakage or damage	WARNING:
has occurred during shipping.
n If all parts have been included, proceed to assembly.	If any parts are missing do not operate this machine until
	the missing parts are replaced. Failure to do so could
	result in possible serious injury.

Page 6