ASSEMBLY
MOUNTING THE SAW TABLE
See Figures 4 and 5.
■Remove the angle adjustment knob from the side of the saw housing. See Figure 5.
Note: Take care when removing the nut and washer from the center of the angle adjustment knob. There is a spring in the center that is released after the nut and washer are removed.
■Remove the table aligning bolt, washer, and wing nut from the saw table.
■Standing at the front of the band saw, slide the saw table through the slot moving from the right side of the saw table to the left.
■Insert the washer on the threaded end of the table lock handle. The table lock handle is spring loaded and is released by pulling the handle away from the saw housing. Tighten the saw table to the saw housing by ratcheting the table lock handle clockwise or by finger tightening the table lock handle.
■Reattach the angle adjustment knob using the spring, washer, and nut.
■Reattach the table aligning bolt, washer, and wing nut to the saw table.
Note: The wing nut goes below the saw table.
9” BAND SAW
TABLE
ALIGNING
BOLT
WASHER
ON
O
WING
NUT
WASHER TABLE
LOCK
HANDLE
Fig. 4
MOUNTING BAND SAW TO WORKBENCH
If the band saw is to be used in a permanent location, we recommend that you secure it to a workbench or other stable surface. When mounting the saw to a workbench, holes should be drilled through the supporting surface of the workbench.
■Each hole in the saw base should be bolted securely using bolts, lock washers, and hex nuts (not included).
■Place band saw on the workbench. Using the saw base as a pattern, locate and mark the holes where the band saw is to be mounted.
■Drill four holes through the workbench.
■Place band saw on the workbench aligning holes in the saw base with the holes drilled in the workbench.
■Insert all four bolts (not included) and tighten securely with lock washers and hex nuts (not included).
Note: All bolts should be inserted from the top. Install the lock washers and hex nuts from the underside of the bench.
Supporting surface where band saw is mounted should be examined carefully after mounting to insure that no movement during use can result. If any tipping or walking is noted, secure workbench or support surface before beginning cutting operation.
Page 10
| WASHER |
TABLE | 4 |
30 | |
| 5 |
LOCK | 15 |
HANDLE | 0 |
|
SPRING
NUT
WASHER
ANGLE
ADJUSTMENT
KNOB
Fig. 5