Ryobi CFS1502 manual Changing the Sanding Sheets and Pads, Rotating the Sanding Sheets

OPERATION

CHANGING THE SANDING SHEETS AND PADS

See Figure 8.

The sander is packed with sanding sheets and pads designed for a variety of uses. To change sheet or pad, simply pull the used sheet or pad off the base and attach the desired sheet or pad by pressing the sheet or pad onto the base of the sander.

PAPER PUNCH

See Figure 9.

A paper punch template has been supplied with the sander for aligning and punching holes in sandpaper. The punched holes must align with the holes in the sander pad.

�n Install sandpaper on the sander.

�n Align the sander pad over the paper punch. �n Push down on the sander.

ROTATING THE SANDING SHEETS

See Figure 10.

The majority of wear in a precision sanding application occurs at the tip of the sanding sheet. The unique Tri-Flex design of the sanding sheets allows you to detach and rotate the top two thirds of each, extending the life of the sheet.

To rotate the top of the sheet, simply remove the top two thirds along the perforation. Rotate the sheet so that a clean corner is located at the tip of the base. Press the sheet firmly onto the sander pad.

NOTE: Scrubbing and polishing pads are not perforated and cannot be rotated.

Fig. 8

HOOK AND LOOP PAD

PAPER PUNCH

Fig. 9

ROTATING SANDING SHEET

Fig. 10

12