OPERATION
STARTING/STOPPING THE SAW
See Figure 10.
SWITCH
To start the saw: Depress the switch trigger.
Always let the blade reach full speed, then guide the saw into the workpiece.
WARNING:
The blade coming in contact with the workpiece before it reaches full speed could cause your saw to “kickback” towards you resulting in serious injury.
To stop the saw: Release the switch trigger.
After you release the switch trigger, allow the blade to come to a complete stop. Do not remove the saw from the workpiece while the blade is moving.
Fig. 10
DEPTH OF CUT
SCALE
ADJUSTING BLADE DEPTH
See Figure 11.
Always keep correct blade depth setting. The correct blade depth setting for all cuts should not exceed 1/4 in. (6.35 mm) below the material being cut. More blade depth will increase the chance of kickback and cause the cut to be rough. For more depth of cut accuracy, a scale is located on the upper blade guard.
Follow these directions to adjust the blade depth.
■ UNPLUG YOUR CIRCULAR SAW. | WING NUT |
| |
WARNING: | BASE |
Fig. 11 |
Failure to unplug the tool could result in accidental starting causing serious injury.
■Loosen wing nut on back of saw.
■Determine the desired depth of cut.
■Locate depth of cut scale on back of upper blade guard.
■Hold base flat against the workpiece and raise or lower saw until the indicator mark on bracket aligns with notch on blade guard.
■Tighten wing nut securely.
14