ACCESSORIES
OPTIONAL RIP GUIDE
Use the optional rip guide, part no.
TO ASSEMBLE RIP GUIDE
See Figure 22.
Follow these directions to assemble the rip guide.
■UNPLUG YOUR CIRCULAR SAW.
WARNING:
Failure to unplug the tool could result in accidental starting causing serious injury.
■Place rip guide through holes in base as shown in the figure.
■Adjust rip guide to the width needed.
■Tighten rip guide knob securely.
TO USE RIP GUIDE
Follow these directions to use the rip guide.
■Secure the workpiece.
■Position the face of the rip guide firmly against the edge of workpiece.
■Guide the saw along the edge to achieve a straight rip cut.
NOTE: The guiding edge of the workpiece must be straight for your cut to be straight. Use caution to prevent the blade from binding in the cut.
OPTIONAL DUST NOZZLE KIT
See Figure 23.
RIP GUIDE
SCREW
RIP GUIDE
Fig. 22
ADAPTER
You may purchase a dust nozzle kit, part no. 982829- 001, for use with your saw. As shown in the figure, the adapter fits over the dust chute which is located on the upper blade guard.The nozzle attaches to the adapter.
NOTE: If you use the nozzle, you should always connect it to a standard vacuum hose.
TO ATTACH DUST NOZZLE
HOLE
DUST
CHUTE
RAISED
LIP
NOZZLE
SCREW
Follow these directions to attach the dust nozzle.
■UNPLUG YOUR CIRCULAR SAW.
WARNING:
Failure to unplug the tool could result in accidental starting causing serious injury.
■Lift lower blade guard.
■Orient adapter to fit into the dust chute opening (1) on upper blade guard.
■Secure adapter with screw (2) provided.
■Align hole in nozzle with raised lip on adapter and snap into place (3) when using a vacuum hose.
Fig. 23
20