OPERATION

POSITIVE 0° BEVEL STOP

See Figure 22.

The saw has a positive 0° bevel stop that has been factory adjusted to assure 0° angle of the saw blade when making 90° cuts.

TO CHECK POSITIVE 0° BEVEL STOP

Follow these directions to check the positive 0° bevel stop.

nUnplug your circular saw.

WARNING:

Failure to unplug the tool could result in accidental start- ing causing serious injury.

nPlace the saw in an upside down position on a work- bench.

nCheck the squareness of the saw blade to the base of the saw using a carpenter’s square.

TO ADJUST POSITIVE 0° BEVEL STOP

Follow these directions to adjust the positive 0° bevel stop.

nUnplug your circular saw.

WARNING:

Failure to unplug the tool could result in accidental start- ing causing serious injury.

nLoosen bevel adjustment knob.

nTurn setscrew with hex key and adjust base until it is square with the saw blade.

nTighten bevel adjustment knob securely.

WARNING:

Attempting a bevel cut without having the bevel ad- justment knob securely tightened can result in serious injury.

LENGTH OF CUT SCALE

See Figure 23.

The saw is equipped with a length of cut scale on its base. It is parallel with the saw blade and you can use it to measure the distance into the material the blade cuts.

NOTE: Six inches is the maximum length of cut that you can measure. Also, it is accurate only when the depth of cut is set at full maximum depth.

� �� �

��

BEVEL

ADJUSTMENT KNOB

CARPENTER’S

SQUARE

SETSCREW

Fig. 22

6

5

4

3

2

1

0

LENGTH OF CUT

 

SCALE

Fig. 23

19

Page 19
Image 19
Ryobi csb140lz manual Positive 0 Bevel Stop, Length of CUT Scale