MAINTENANCE
WARNING:
When servicing use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or de- stroy plastic which may result in serious personal injury.
Electric tools used on fiberglass material, wallboard, spack- ling compounds, or plaster are subject to accelerated wear and possible premature failure because the fiberglass chips and grindings are highly abrasive to bearings, brushes, com- mutators, etc. Consequently, we do not recommended using this tool for extended work on these types of materials. How- ever, if you do work with any of these materials, it is extremely important to clean the tool using compressed air.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal operating conditions. Therefore, no further lubrication is required.
REPLACING LASER GUIDE BATTERIES
See Figure 26.
�n Unplug the saw.
�n Make sure laser is turned off.
nRemove the laser cover by lifting it off its base. �n Remove both AAA batteries.
�n Install the two AAA batteries aligning the positives (+) with positives (+) and the negatives
�n Replace the laser cover.
nTurn on laser.
CAUTION:
Use of controls or adjustments or performance other than those specified herein may result in hazardous radiation exposure.
Fig. 26
21
