OPERATION
WARNING:
Be prepared for binding or breakthrough. When these situations occur, the drill has a tendency to grab and kick in the opposite direction, and could cause loss of control when breaking through material. If you are not prepared, this loss of control can result in possible serious injury.
When drilling metals, use a light oil on the drill bit to keep it from overheating. The oil will prolong the life of the bit and increase the drilling action.
If the bit jams in workpiece or if the drill stalls, release switch trigger immediately. Remove the bit from the workpiece and determine the reason for jamming.
SCREWDRIVING
TORQUE ADJUSTMENT
(Driving power of your drill-driver)
When using your
The torque is adjusted by rotating the torque adjustment ring. See Figure 11. The torque is greater when the torque adjustment ring is set on a higher setting. The torque is less when the torque adjustment ring is set on a lower setting.
The proper setting depends on the type of material and the size of screw you are using.
TO ADJUST TORQUE
■Identify the twenty four torque indicator settings located on the front of your drill. See Figure 11.
■Rotate adjustment ring to the desired setting.
•1 - 4 For driving small screws.
•5 - 8 For driving screws into soft material.
•9 - 12 For driving screws into soft and hard materials.
•13 - 16 For driving screws in hard wood.
•17 - 20 For driving large screws.
•21 - 24 For heavy drilling.
BIT STORAGE
See Figure 12.
When not in use, bits provided with your drill can be placed in the storage area located on the top of your drill as shown in figure 12.
TORQUE ADJUSTMENT RING
TO DECREASE
TORQUE
2
22 20
18 
16
TO INCREASE |
|
TORQUE | Fig. 11 |
SCREWDRIVER | BIT STORAGE AREA |
BIT |
|
2
22 20
18 
16
SCREWDRIVER
BIT
Fig. 12
WARNING:
Always wear safety goggles or safety glasses with side shields when operating tool. Failure to do so could result in objects being thrown into your eyes, resulting in possible serious injury.
Page 11
