Ryobi CTH1442K2, CTH1802 Specifications DRILL-DRIVER, Charger, Disposal of the Exhausted Battery

SPECIFICATIONS:

DRILL-DRIVER	CTH1202K2	CTH1442K2	CTH1802
Chuck	3/8 in. Keyless	3/8 in. Keyless	1/2 in. Keyless
Motor	DC Motor 12.0 V	DC Motor 14.4 V	DC Motor 18.0 V
Gear Train	Two-Speed	Two-Speed	Two-Speed
Switch	Variable Speed	Variable Speed	Variable Speed
No Load Speed	0-300 RPM (Low)	0-350 RPM (Low)	0-350 RPM (Low)
	0-1000 RPM (High)	0-1300 RPM (High)	0-1300 RPM (High)
Clutch	24 Positions	24 Positions	24 Positions
CHARGER	1400666	1400656	1400667
Input	120 V, 60 Hz, AC only	120 V, 60 Hz, AC only	120 V, 60 Hz, AC only
Charging Voltage	12.0 V	14.4 V	18.0 V
Charge Rate	1 Hour	1 Hour	1 Hour

IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES

When using your drill-driver continuously, the batteries in your battery pack become hot. You should let a hot battery pack cool down for approximately 30 minutes before at- tempting to recharge.

Note: This situation occurs when continuous use of your drill-driver causes the batteries to become hot. It does not

occur under normal circumstances. Refer to "Charging Your Drill-Driver"for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest RYOBI AUTHORIZED SERVICE CENTER for electrical check.

DISPOSAL OF THE EXHAUSTED BATTERY

		CYC							To preserve natural resources, please
	E			L
R					E				recycle or dispose of batteries properly.
		R B R C
									This product contains nickel-cadmium
.		N i		C d				7	battery. Local, state, or federal laws may
1							3
8
						8
0									prohibit disposal of Nickel-Cadmium
	0.				8
			.
			8	22					batteries in ordinary trash.

Consult your local waste authority for information regarding available recycling and/or disposal options.

For more information on battery recycling call 1-800-8

BATTERY.

BATTERY PACK PREPARATION FOR RECYCLING

WARNING:

Upon removal, cover the battery pack's terminals with heavy duty adhesive tape. Do not attempt to destroy or disassemble battery pack or remove any of its components. Also, never touch both terminals with metal objects and/or body parts, as short circuit may result. Keep away from children. Failure to comply with these warnings could result in fire and/or serious injury.

WARNING:

Do not attempt to disassemble the battery pack. Fire or injury may result.

WARNING:

The operation of any power tool can result in foreign objects being thrown into your eyes, which can result in severe eye damage. Before beginning power tool operation, always wear safety goggles or safety glasses with side shields and a full face shield when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or standard safety glasses with side shields.

Page 6