OPERATION
DRILLING
See Figure 6 - 7.
Levels are located on the top and end of the motor housing to help keep the drill bit level during use.
Depress and release the switch trigger to be sure the drill is in the OFF position before connecting it to a power supply.
Check the direction of rotation selector for the correct setting (forward or reverse).
Secure the material to be drilled in a vise or with clamps to keep it from turning as the drill bit rotates.
Plug the drill into power supply. Hold the drill firmly and place the bit at the point to be drilled.
Depress the switch trigger to start the drill.
Move the drill bit into the workpiece, applying only enough pressure to keep the bit cutting. Do not force the drill or apply side pressure to elongate a hole. Let the tool do the work.
WARNING:
Be prepared for binding at bit breakthrough. When these situations occur, the drill has a tendency to grab and kick in the opposite direction and could cause loss of control when breaking through material. If not prepared, this loss of control can result in possible serious injury.
When drilling hard, smooth surfaces, use a center punch to mark the desired hole location. This will prevent the drill bit from slipping
When drilling metals, use a light oil on the drill bit to keep it from overheating. The oil will prolong the life of the bit and increase the drilling action.
If the bit jams in the workpiece or if the drill stalls, stop the tool immediately. Remove the bit from the workpiece and determine the reason for jamming.
LEVEL
Fig. 6
LEVEL
Fig. 7
12 − English
