ASSEMBLY
installing chuck, head assembly, and feed handles
See Figures 9 - 11.
NOTE: Move the table out of the way before beginning installation.
Position the head assembly onto the column with the
chuck positioned over the table. |
| |
NOTE: The head assembly is heavy. Get help when |
| |
needed. |
| |
Slide the head assembly down as far as it will go. Align |
| |
the head assembly with the base then tighten the two | HUB | |
head set screws with the hex key. | ||
| ||
Attach the three feed handles by screwing them into the |
| |
threaded holes in the hub. |
| |
Position chuck on spindle. Chuck should be fully opened |
| |
to avoid damaging jaws. |
| |
Using a piece of scrap wood to protect the chuck, firmly |
| |
tap the chuck into place using a mallet or hammer. |
| |
Fit the spindle into the spindle shaft turning it to the right |
| |
until it slips into place and tap with mallet using a piece |
| |
of wood. |
|
set
screws
head
assembly
head 
assembly
spindle
Fig. 9
chuck
feed
handle
Fig. 10
Fig. 11
15
