OPERATION
KNOW YOUR DRILL-DRIVER
See Figure 1.
Before attempting to use any tool, familiarize yourself with all operating features and safety requirements.
WARNING:
Do not allow familiarity with tools to make you careless. Remember that a careless fraction of a second is sufficient to inflict severe injury.
CHARGING YOUR DRILL-DRIVER
The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it at least 6 hours prior to use.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (drilling followed by re- charging) for them to fully charge.
TO CHARGE
■Charge battery pack only with the charging assembly provided.
■Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.
■Connect charging assembly to power supply.
■Place battery pack in charging assembly. Align raised rib on battery pack with groove in charging assembly. See Figure 2.
■Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charging assembly. When properly connected, red light will turn on.
■After normal usage, 3 hours of charging time is re- quired to be fully charged. A minimum charge time of 6 hours is required to recharge a completely discharged battery.
■The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
■DO NOT place charging assembly in an area of ex- treme heat or cold. It will work best at normal room temperature.
TORQUE LEVEL ADJUSTMENT
RING
8
6
4 
2 
SWITCH
TRIGGER
KEYLESS
CHUCK
MAG TRAY™
(SCREW HOLDER)
BATTERY
PACK
CHARGING
ASSEMBLY
BIT
STORAGE
AREA
DIRECTION
OF ROTATION
SELECTOR
BATTERY
PACK
Fig. 1
CHARGE
INDICATOR LIGHT (LED)
Fig. 2
Page 7
