OPERATION
WARNING:
If any parts are missing, do not operate tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
SWITCH
See Figure 3.
Your drill starts and stops by depressing and releasing the switch trigger.
VARIABLE SPEED
Your drill has a variable speed feature in the switch. The switch delivers higher speed and torque with increased trigger pressure. Speed is controlled by the amount of switch trigger depression.
SWITCH LOCK
See Figure 3.
The switch trigger can be locked in the OFF position. This feature helps reduce the possibility of accidental starting when not in use. To lock the switch trigger, place the direction of rotation selector in the center position.
TO INSTALL BATTERY PACK
■Place the direction of rotation selector in center posi- tion. See Figure 3.
■Place the battery pack in your drill. Align raised rib on battery pack with groove in drill's battery port. See Figure 4.
■Make sure the latches on each side of your battery pack snap in place and that battery pack is secured in drill before beginning operation.
TO REMOVE BATTERY PACK
■ | Place the direction of rotation selector in center posi- |
| tion. See Figure 3. |
■ | Locate latches on side of battery pack and depress both |
| sides to release battery pack from your drill. |
CENTER POSITION
(LOCK)
| REVERSE | DIRECTION |
10 |
| OF ROTATION |
|
| |
8 |
| SELECTOR |
|
| |
6 |
|
|
2 |
|
|
SWITCH
TRIGGER
FORWARD
Fig. 3
10
8
6
4
2
BATTERY
See Figure 4. |
■ Remove battery pack from your drill. |
CAUTION:
BATTERY
PACK
PORT
LATCHES
When placing battery pack in your drill, be sure raised rib on battery pack aligns with groove in drill's battery port and latches snap in place properly. Improper assembly of battery pack may cause damage to internal components.
DEPRESS LATCHES |
TO RELEASE |
BATTERY PACK |
Fig. 4
Page 8
