Warning!
Dangerous electrical voltage!
Before commencing the installation
•Disconnect the power supply of the device.
•Ensure that devices cannot be accidentally restarted.
•Verify isolation from the supply.
•Short circuit to earth.
•Cover or enclose neighboring units that are live.
•Follow the engineering instructions (AWA) of the device concerned.
•Only suitably qualified personnel in accordance with EN
•Before installation and before touching the device ensure that you are free of electrostatic charge.
•The functional earth (FE) must be connected to the protective earth (PE) or to the potential equalization. The system installer is responsible for implementing this connection.
•Connecting cables and signal lines should be installed so that inductive or capacitive interference does not impair the automation functions.
•Install automation devices and related operating elements in such a way that they are well protected against unintentional operation.
•Suitable safety hardware and software measures should be implemented for the I/O interface so that a line or wire breakage on the signal side does not result in undefined states in the automation devices.
•Ensure a reliable electrical isolation of the low voltage for the 24 volt supply. Only use power supply units complying with IEC
•Deviations of the mains voltage from the rated value must not exceed the tolerance limits given in the specifications, otherwise this may cause malfunction and dangerous operation.
Eaton Safety instructions |
|
|
|
|
| MN05013001E | For more information visit: www.EatonElectrical.com | I |
|
