Ryobi HP36KF INSERTING/REMOVING BITS, ADJUSTING TORQUE (SCREWDRIVER), ADJUSTING TOOL ANGLE, BIT, NOTE:, PRESS, COLLET, TORQUE, TORQUE, MOVE DOWN, TO INCREASE, TO DECREASE

ADJUSTMENTS

WARNING:

Your screwdriver/flashlight combination should never be connected to power supply when you are assembling parts, making adjustments, cleaning, performing maintenance, or when not in use. Disconnecting your tools will prevent accidental starting that could cause serious injury.

INSERTING/REMOVING BITS

See Figure 2.

Follow these directions when inserting and removing bits.

■To insert bit: Insert shank end of bit into collet.

■To remove bit: Remove bit when finished and place in storage cradle.

ADJUSTING TORQUE (SCREWDRIVER)

See Figure 3.

Follow these directions when adjusting torque.

■Locate arrow on torque adjustment cap.

■To increase torque: Turn torque adjustment cap coun- terclockwise.

■To decrease torque: Turn torque adjustment cap clockwise.

ADJUSTING TOOL ANGLE

See Figure 4.

Follow these directions when adjusting tool angle.

■Press angle adjustment button.

■Move head of tool down until it snaps into place.

NOTE: To return tool to original position, press angle adjustment button and move head of tool up until it snaps into place.

22

19

16 13

COLLET

BIT

Fig. 2

TO INCREASE

TORQUE

22

19

16 13

TO DECREASE

TORQUE

Fig. 3

PRESS

MOVE DOWN

22

19

16 13

Fig. 4

9