MAINTENANCE AND REPAIR INSTRUCTIONS
Blade Cover
Screw
Fig. 12
Fig. 13
8.Replace blade screws. Tighten screws securely.
9.Replace blade cover screw (Fig. 14).
NOTE: Do not tighten blade cover screw until blade cover has been replaced.
10.Replace blade cover. Place rear tab inside housing, align front tabs with slots in housing, then slide blade cover back into its correct position (Fig. 15).
11.Tighten blade cover screw securely.
Fig. 14
Fig. 15
WARNING: Make sure blade cover is replaced before connecting your hedge trimmer to power supply. Failure to do so will expose internal parts which could cause an accident or electrical shock resulting in serious injury.
NOTE: If binding occurs after replacing blade assembly, repeat the steps above for reassembly.
11
