OPERATION
When cutting crown molding by this method the bevel angle should be set at 33.85°. The miter angle should be set at 31.62° either right or left, depending on the desired cut for the application. See the chart below for correct angle settings and correct positioning of crown molding on miter table.
The settings in the chart below can be used for cutting All Standard (U.S.) crown molding with 52° and 38° angles. The crown molding is placed flat on the miter table using the compound features of your miter saw.
4 5
31.6 | 30 |
22.5
15
0
4 | 5 |
|
30 | 31.6 |
|
22.5
15
Bevel |
|
| |
Angle |
| Type of Cut | |
Setting |
|
| |
|
| ||
| Left side, inside corner | ||
33.85° | 1. | Top edge of molding against fence | |
2. | Miter table set right 31.62° | ||
| |||
| 3. | Save left end of cut | |
|
| ||
| Right side, inside corner | ||
33.85° | 1. Bottom edge of molding against fence | ||
2. | Miter table set left 31.62° | ||
| |||
| 3. | Save left end of cut | |
|
| ||
| Left side, outside corner | ||
33.85° | 1. Bottom edge of molding against fence | ||
2. | Miter table set left 31.62° | ||
| |||
| 3. | Save right end of cut | |
|
| ||
| Right side, outside corner | ||
33.85° | 1. | Top edge of molding against fence | |
2. | Miter table set right 31.62° | ||
| |||
| 3. | Save right end of cut | |
|
|
| |
CUTTING WARPED MATERIAL
See Figures 40 and 41.
When cutting warped material, always make sure it is positioned on the miter table with the convex side against the fence as shown in figure 40.
RIGHT | Fig. 40 |
|
If the warped material is positioned the wrong way as shown in figure 41, it will pinch the blade near the completion of the cut.
5 |
|
| 5 |
4 |
| 4 |
|
3 |
| .6 |
|
1.6 | 3 | 31 |
|
| 30 |
| |
| 0 |
| |
| 22.5 | 22.5 |
|
| 15 | 15 |
|
|
| 0 |
|
WRONG | Fig. 41 |
|
WARNING:
To avoid a kickback and to avoid serious personal injury, never position the concave edge of bowed or warped material against the fence.
30
