MAINTENANCE
WARNING:
When servicing, use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.
WARNING:
To avoid serious personal injury, always remove the battery pack from the tool when cleaning or performing any maintenance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.
Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at a Ryobi Authorized Service Center.
REMOVING THE CHUCK
See Figures 14 - 16.
nLock the trigger switch by placing the rotation selector in the center position.
nInsert a 5/16 inch or larger hex key wrench into the chuck of the drill and tighten the chuck jaws securely.
nTap the hex key wrench sharply with a mallet in a clock- wise direction. This will loosen the screw in the chuck for easy removal.
nOpen the chuck jaws and remove the hex key wrench.
nRemove the chuck screw by turning it in a clockwise direction.
NOTE: The screw has
nInsert the hex key wrench in the chuck and tighten the chuck jaws securely.
nTap sharply with a mallet in a counterclockwise direction. This will loosen chuck on the spindle. It can now be un- screwed by hand.
CHUCK JAWS | MALLET |
|
15
HEX KEY
KEYLESS
CHUCK
Fig. 14
15
SCREWDRIVER
Fig. 15
15
Fig. 16
17
