OPERATION

WARNING:

DEPRESS LATCHES TO

Always remove battery pack from your saw when you are assembling parts, making adjustments, assembling or removing blades, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury.

TO REMOVE BATTERY PACK

Locate latches on end of battery pack and depress to release battery pack from your saw. See Figure 4.

Remove battery pack from your saw.

WARNING:

Failure to remove battery pack from saw could result in accidental starting causing possible serious personal injury.

 

50

 

45

30

22

 

3

 

2

 

1

45

 

0

1

RELEASE BATTERY PACK

LATCHES

BATTERY

PACK

Fig. 4

TO INSTALL BATTERY PACK

See Figure 4.

Place battery pack in your saw. Align raised rib inside saw with groove on battery pack.

Make sure the latches on each side of your battery pack snap in place and battery pack is secured in saw before beginning operation.

CAUTION:

When placing battery pack in your saw, be sure raised rib inside saw aligns with groove on battery pack and latches snap in place properly. Improper assembly of battery pack can cause damage to internal components.

WARNING:

A 5-1/2 in. (140 mm) blade is the maximum blade capacity of your saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guard, while thicker blades will prevent blade screw from securing blade on spindle. Either of these situations could result in a serious accident.

TO ASSEMBLE OR REMOVE BLADE

TO ASSEMBLE BLADE:

Remove battery pack from saw.

WARNING:

Failure to remove battery pack from saw could result in accidental starting causing possible serious personal injury.

SPINDLE

LOCK

BUTTON

SPINDLE

50 45

230 2

3

2

1

45

0

1

INNER

 

 

 

 

BLADE

BLADE

LOWER

WASHER

OUTER

SCREW

BLADE

BLADE

 

GUARD

 

BLADE WASHER

Fig. 5

HANDLE

Locate latches on end of battery pack and depress to release battery pack from your saw. See Figure 4.

Remove blade wrench (5 mm hex key) from storage area. See Figure 1.

Depress spindle lock button and remove blade screw and outer blade washer. See Figure 5.

NOTE: Turn blade screw clockwise to remove.

Wipe a drop of oil onto inner blade washer and outer blade washer where they contact blade.

WARNING:

If inner blade washer has been removed, replace it before placing blade on spindle. Failure to do so could cause an accident since blade will not tighten properly.

Page 9

Page 9
Image 9
Ryobi R10632 specifications To Install Battery Pack, To Assemble or Remove Blade