OPERATION
WARNING:
Exercise caution when using this tool. Careless actions, for even a fraction of a second, can result in serious personal injury.
You may use the router for the purposes listed below:
■Routing Grooves, shaping edges, etc. in wood.
■Chamfering, rabbeting, dadoing, and dovetailing in wood.
■Routing edges on plastic laminates.
ON
OFF
Fig. 2
WARNING:
Always wear safety goggles or safety glasses with side shields when using your router. Failure to do so could result in dust, shavings, chips, loose particles, or foreign objects being thrown in your eyes resulting in possible serious injury. If the operation is dusty, also wear a face or dust mask.
TURNING THE ROUTER ON/OFF
See Figure 2.
■ To turn on the router: Toggle the switch to the I position.
■ To turn off the router: Toggle the switch to the O position.
OPERATING THE ROUTER
See Figure 3.
Follow these steps to operate the router. | Fig. 3 |
1. Unplug the router. |
|
WARNING:
Failure to unplug the tool could result in accidental starting causing serious injury.
2.Securely tighten the cutter in the collet nut. Refer to “Removing/Inserting Cutters” later in this manual.
3.Set the desired depth of cut. Refer to “Adjusting Depth of Cut” later in this manual.
4.Secure the workpiece.
5.Plug the router into a power source.
6.Hold the router firmly with both hands.
7.Turn on the router and let the motor build to its full speed.
8.Feed the cutter slowly into the workpiece.
NOTE: Do not let the cutter contact the workpiece before starting the router and allowing it to develop full speed.
9.Turn off the router upon completion of cut, and let the motor come to a complete stop before removing the router from the workpiece.
WARNING:
Never place the router down on a work surface before the cutter stops.
10
