OPERATION
LED FUNCTION OF CHARGER
See Figure 5.
LED WILL BE LIGHTED TO INDICATE STATUS OF CHARGER AND BATTERY PACK:
■Red LED lighted = Fast Charging Mode
■Green LED lighted = Fully Charged Battery Pack
■Yellow and Green LED Lighted = Control Charge or Possible Faulty Battery.
CHARGING BATTERY PACK
The battery pack for this tool has been shipped in a low charge condition to prevent possible problems. Therefore, you should charge it prior to use.
Note: Batteries will not reach full charge the first time they are charged. Allow several cycles (cutting followed by re- charging) for them to fully charge.
TO CHARGE
■Charge battery pack only with the charger provided.
■Make sure power supply is normal house voltage, 120 volts, 60 Hz, AC only.
■Connect charger to power supply.
■Place battery pack in charger. See Figure 6. Align raised rib on battery pack with groove in charger.
■Press down on battery pack to be sure contacts on battery pack engage properly with contacts in charger. When properly connected, red light will turn on.
■Normally, the yellow and green lights on the charger will come on. This indicates charger is in control charge mode and should switch to fast charge mode within 5 minutes. When charger is in fast charge mode the red light will come on. If after a period of 15 minutes the yellow and green lights remain on, remove the battery pack, wait 1 minute and reinsert battery pack in charger. If the yellow and green lights continue to remain on an additional 15 minutes, the battery pack is damaged and will not accept charge.
■When your battery pack becomes fully charged, the red light will turn off and the green light will turn on.
■After normal usage, 1 hour of charge time is required to be fully charged. A minimum charge time of 1 to
■The battery pack will become slightly warm to the touch while charging. This is normal and does not indicate a problem.
■Do not place charger in an area of extreme heat or cold. It will work best at normal room temperature.
■When the batteries become fully charged, unplug your charger from power supply and remove the battery pack.
GREEN LIGHT "ON" | BATTERY | |
INDICATES FULLY | ||
CHARGER | ||
CHARGED | ||
|
| RED LIGHT "ON" |
YELLOW AND GREEN LIGHTS "ON" | INDICATES FAST |
CHARGING MODE | |
INDICATES CONTROL CHARGE OR |
|
POSSIBLE FAULTY BATTERY | Fig. 5 |
| |
|
|
BATTERY PACK SHOWN
ATTACHED TO CHARGER
BATTERY
CHARGER
BATTERY
PACK
Fig. 6
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your reciprocating saw continuously, the batteries in your battery pack become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge.
Note: This situation occurs when continuous use of your saw causes the batteries to become hot. It does not occur under normal circumstances. Refer to "CHARGING BAT- TERY PACK" for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Authorized Service Center for electrical check.
Page 9
