OPERATION
TURNING THE SANDER ON/OFF
See Figure 4.
Follow these directions to turn the sander on and off.
nTo turn the sander on: Slide the switch to the left ().
nTo turn the sander off: Slide the switch to the right (O).
ADJUSTING THE SPEED
See Figures 4 - 5.
The variable speed feature allows the sander to operate at speeds that can be adjusted by rotating the dial from A to F. The dial is conveniently located on the motor housing, allowing operator control of disc speed.
nTo increase the speed: Turn the dial to a higher setting (towards F).
nTo decrease the speed: Turn the dial to a lower setting (towards A).
WARNING:
To prevent the possibility of sanding dust or foreign objects being thrown into the face or eyes, never attempt to use the sander without the dust bag properly installed. Sanding dust or foreign objects being thrown into the face could result in possible serious personal injury.
DUSTLESS SANDING
The dust bag assembly provides a dust collection system for the sander. Sanding dust is drawn up through the holes of the sanding disc to collect in the dust bag during sanding operation.
NOTE: For more efficient operation, empty dust bag when no more than half full. This will permit the air to flow through the bag better.
TO
TURN ON
VARIABLE
SPEED DIAL
TO
TURN OFF
Fig. 4
TO | TO |
INCREASE | |
DECREASE |
|
Fig. 5
11
