Ryobi RY09460 Troubleshooting, Problem, Cause, Remedy, Adding/Checking Engine Lubricant in

Models: RY09460

1 48
Download 48 pages 52.67 Kb
Page 17
Image 17
TROUBLESHOOTING

TROUBLESHOOTING

IF THESE SOLUTIONS DO NOT SOLVE THE PROBLEM, CONTACT YOUR AUTHORIZED SERVICING DEALER.

PROBLEM

 

CAUSE

REMEDY

Engine fails to start.

No fuel in tank.

Fill tank.

 

Spark plug shorted or fouled.

Replace spark plug.

 

Spark plug is broken. (cracked

Replace spark plug.

 

porcelain­

or electrodes broken)

 

 

Ignition lead wire shorted, broken, or

Replace lead wire or attach to spark

 

disconnected from spark plug.

plug.

 

Ignition inoperative.

Contact authorized service center.

 

 

 

Engine hard to start.

Water in gasoline or stale fuel.

Drain entire system and refill with fresh

 

 

 

fuel.

 

Engine is under or over choked.

Adjust choke as necessary.

 

Weak spark at spark plug.

Contact authorized service center.

 

 

 

Engine lacks power.

Air filter clogged.

Clean air filter. Refer to Cleaning the

 

 

 

Air Filter Screen earlier in this manual.

 

 

 

Engine starts, runs, and accelerates

Idle speed screw on carburetor needs

Turn idle speed screw clockwise to in-

but will not idle

adjustment.

crease idle speed. See Figure 16.

 

 

 

Engine emits too much smoke

Too much oil in crankcase.

Drain lubricant and refill with correct

 

 

 

amount of 10W-30 engine lubricant. See

 

 

 

Adding/Checking Engine Lubricant in

 

 

 

the Operation section of this manual.

 

 

 

Engine rope cannot be pulled

Oil has entered the combustion

This is usually caused by storing the unit

 

chamber.

 

for an extended time with the engine in

 

 

 

an upside-down position. Remove and

 

 

 

clean the spark plug. Drain the oil out

 

 

 

of the spark plug hole, then reinstall the

 

 

 

spark plug.

 

 

 

 

13 - English

Page 17
Image 17
Ryobi RY09460 manuel dutilisation Troubleshooting, Problem, Cause, Remedy, Adding/Checking Engine Lubricant in