Ryobi RY30570, RY30931 manual Attaching the Front handle CS30 and SS30, Attaching the J Handle BC30

ASSEMBLY

ATTACHING THE FRONT handle - CS30 and SS30

See Figure 4.

Remove wing nut, washer, and bolt from the front handle.

Install the front handle onto the top side of the drive shaft housing in the area indicated by the label.

NOTE: The open side of the handle should face the operator. 

Place the bolt through the front handle.

NOTE: The hex bolt head fits inside the hex recess molded into one side of the handle.

Reinstall the washer and wing nut.

Tighten wing nut securely.

ATTACHING THE “J” HANDLE - BC30

See Figure 5.

A “J” handle must be used for ensuring the best control and maximizing operator safety when using a brushcutter.

Hold the top and bottom clamp snugly in position on the shaft housing so that handle will be located to the operator’s left.

Insert the end of the handle between the clamps.

Align the bolt holes and push the long bolt (1/4-20 x 1-1/2 in.) through the handle side.

Place short bolt (1/4-20 x 1 in.) through opposite side of clamp. Install flat washers, lock washers, and hex nuts to hold the assembly in place.

After assembly is complete, adjust the position of the handle to the area indicated by the label on the drive shaft housing.

Tighten first the long bolt and then the short bolt.

FRONT HANDLE

BOLT

WASHER WING NUT

Fig. 4

	bolt
FRONT	1/4-20 x 1 in.	bolt
		1/4-20 x 1-1/2 in.
HANDLE

strap hanger

CLAMP

CLAMP	FLAT WASHER
	LOCK WASHER
HEX NUT	Fig. 5

12