Ryobi RY42110 Attaching And Extending The Blower/Vac Tube, Attaching And Removing The Vacuum Bag

Models: RY42110

1 38
Download 38 pages 32 Kb
Page 10
Image 10
ATTACHING AND EXTENDING THE BLOWER/VAC TUBE

ASSEMBLY

WARNING:

If any parts are damaged or missing do not operate this product until the parts are replaced. Use of the product with damaged or missing parts could result in possible serious personal injury.

WARNING:

Do not attempt to modify this product or create acces- sories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.

WARNING:

To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.

WARNING:

To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.

ATTACHING AND EXTENDING THE BLOWER/VAC TUBE

See Figures 2 - 3.

Slide the blower/vac tube into the motor housing.

Latch into place. Be sure the latches are closed and the tube and motor housing are securely together.

Push the tube lock button down and pull the lower tube out of the upper tube by holding the front bracket to fully telescope the tube out. You will hear a “click” sound when the tubes are fully extended and locked into place.

ATTACHING AND REMOVING THE

VACUUM BAG

See Figure 4.

WARNING:

Never run the unit without the vacuum tube and vacuum bag installed. Use of an improperly assembled unit could result in serious personal injury.

Slide opening of the plastic bracket on the vacuum bag over the discharge outlet on the bottom of the motor housing.

Pull the tab on the plastic bracket out and push plastic bracket and vacuum bag onto motor housing. Let tab lock into slot on motor housing.

Push clip, located on front of vacuum bag, into vacuum bag hook, on underside of blower/vac tube.

To remove the vacuum bag, pull the vacuum bag hook slightly back and pull the vacuum bag clip out.

ATTACHING THE SHOULDER STRAP

See Figure 5.

Clip the shoulder strap into the shoulder strap hook on the rear handle.

Adjust the shoulder strap so that it is in a comfortable position for you.

8 - English

Page 10
Image 10
Ryobi RY42110 Attaching And Extending The Blower/Vac Tube, Attaching And Removing The Vacuum Bag, Assembly, See Figures