OPERATING INSTRUCTIONS
OPERATING THE COUPLER
The coupler enables the use of both trimmer and blower.
Removing Add-On Attachments:
WARNING: Battery tools do not have to be plugged into an electrical outlet; therefore, they are always in operating condition. To prevent serious personal injury, take extra precaution and care when removing or installing
1. Turn the knob counterclockwise to loosen (Fig. 6).
NOTE: To make installing or removing the
| Electrical Connections |
|
| |
Coupler |
|
| ||
| Release | Release Button | ||
| Button Hole |
|
| |
|
|
|
|
|
|
|
|
|
|
Knob
Upper Wire
HousingGuide Recess Lower Wire
Housing
Fig. 6
2.Press and hold the release button (Fig. 6).
3.While firmly holding the coupler housing, pull the cutting attachment or blower attachment straight out of the coupler (Fig. 6).
Installing Add-On Attachments:
1.Turn knob counterclockwise to loosen (Fig.6).
2.Align the groove on the lower wire housing of the attachment with the ridge on the coupler (Fig. 7).
CAUTION: Do not force attachment. To prevent damage to the attachment or coupler, ensure alignment is made before installing
3.While firmly holding the lower wire housing, push it straight into the coupler until release button clicks into place (Fig. 7).
4.Turn the knob clockwise to tighten (Fig. 7). Do not over tighten.
CAUTION: Lock the release button in the release button hole and securely tighten the knob before operating this unit.
Coupler
Large
Connection
Lower Wire
Housing
Ridge
Knob
GrooveTighten
Fig. 7
HANGER
A plastic hanger (Fig. 8) comes attached to the end of the blower shaft housing. Install the hanger on the cutting attachment or blower attachment to help in storing out of the way when not in use.
•Push the release button on the motor wire housing and pull the hanger to remove.
•Align the hole in the hanger with the release button on the motor wire housing and press to install.
Fig. 8
9