MAINTENANCE
WARNING:
When servicing, use only identical Ryobi replacement parts. Use of any other parts may create a hazard or cause product damage.
WARNING:
Always wear safety goggles or safety glasses with side shields during power tool operation or when blowing dust. If operation is dusty, also wear a dust mask.
WARNING:
Before inspecting, cleaning or servicing the machine, shut off engine, wait for all moving parts to stop, and discon- nect spark plug wire and move it away from spark plug. Failure to follow these instructions can result in serious personal injury or property damage.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible to damage from various types of commercial solvents and may be damaged by their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, petroleum- based products, penetrating oils, etc., come in contact with plastic parts. Chemicals can damage, weaken or destroy plastic which may result in serious personal injury.
Only the parts shown on the parts list are intended to be repaired or replaced by the customer. All other parts should be replaced at a Ryobi Authorized Service Center.
Before running the engine, perform the following
nCheck that all bolts, nuts, etc. are securely tightened.
n�Make sure the air filter is clean.
n�Check both the engine oil level and the fuel tank level; refill as needed.
n�Inspect the work area for hazards.
n�If there is excessive noise or vibration, stop the unit immediately.
CLEANING THE AIR FILTER
See Figure 19.
A dirty air filter will cause starting difficulty, loss of performance, and shorten the life span of the engine. Check the air filter monthly. If working in dusty soil, clean the
air filter after each refueling. For best performance, replace the air filter at least once a year.
To clean the air filter:
nRemove the cover.
AIR FILTER
COVER
AIR FILTER 
WIRE MESH 
Fig. 19
nLift the edge of the air filter carefully and pull it out.
nWash the air filter with warm, soapy water.
nRinse and squeeze to dry.
nPut small amount of 30 wt. motor oil on the filter sponge. Squeeze out the excess oil then reinstall the air filter.
NOTE: Make sure the filter is seated properly inside the cover. Installing the filter incorrectly will allow dirt to enter the engine, causing rapid engine wear.
nReinstall the cover.
OIL CAP / DIP
STICK
OIL PLUG | CONTAINER |
Fig. 20
16
