Ryobi Outdoor CS30 RY30020A, SS30 RY30040A, BC30 RY30060A manual Attaching the J Handle BC30

ASSEMBLY

ATTACHING THE FRONT HANDLE - CS30 AND SS30

See Figure 4.

nRemove the front handle, bolt, flat washer, lock washer, and wing nut from the Operator’s Kit.

nInstall the front handle onto the top side of the drive shaft housing and move it to a comfortable position.

nPlace the bolt through the front handle.

NOTE: The hex bolt head fits inside the hex recess molded into one side of the handle.

nInstall the flat washer, lock washer, and wing nut.

nTighten wing nut securely.

ATTACHING THE “J” HANDLE - BC30

See Figure 5.

A “J” handle must be used for ensuring the best control and maximizing operator safety when using a brushcutter.

nHold the top and bottom clamp snugly in position on the shaft housing so that handle will be located to the operator’s left.

nInsert the end of the handle between the clamps.

nAlign the bolt holes and push the long bolt (1/4-20 x 1-1/2 in.) through the handle side.

nPlace short bolt (1/4-20 x 1 in.) through opposite side of clamp. Install flat washers, lock washers, and hex nuts to hold the assembly in place.

nAfter assembly is complete, adjust the position of the handle for best balance and comfort.

nTighten first the long bolt and then the short bolt.

FRONT HANDLE	LOCK
	WASHER

WING

NUT

BOLT

	FLAT WASHER		Fig. 4
	BOLT
FRONT	1/4-20 x 1 in.	BOLT
		1/4-20 x 1 1/2 in.
HANDLE
			STRAP
			HANGER
CLAMP

CLAMP	FLAT WASHER
	LOCK WASHER
HEX NUT	Fig. 5

Page 11