ASSEMBLY
ASSEMBLY INSTRUCTIONS:
GRASS DEFLECTOR
See Figure 2.
1.Remove wing nut, flat washer, lock washer and bolt from the Owner’s Kit.
2.Place grass deflector over shaft and bracket.
3.Install bolt through the slots in the tabs on grass deflector and bracket on drive shaft housing.
4.Install flat washer, lock washer and wing nut.
5.Tighten securely.
GRASS DEFLECTOR
BOLT
FLAT WASHER
LOCK WASHER
WING NUT
BRACKET | Fig. 2 |
|
FRONT HANDLE
See Figure 3.
1.Remove the front handle, bolt and wing nut from the Owner’s Kit.
2.Install the front handle onto the top side of the drive shaft housing and move it to a comfortable position.
3.Place the bolt through the front handle as shown. Then install the wing nut.
4.Tighten the wing nut securely.
NOTE: Do not attempt to remove or modify the spacer. This spacer limits the upper position of the handle grip.
See Figure 3
FRONT HANDLE
WING NUT
BOLT
Fig. 3
SILENCER GUARD ASSEMBLY
See Figure 4.
1.Remove silencer guard and two screws from the owner’s kit.
2.Attach the silencer guard to the rear housing.
NOTE: Make sure the bent end of the silencer guard fits securely into the opening of the rear housing.
3.Install two screws.
4.Tighten screws securely.
REAR
HOUSING
TORQUE | SILENCER |
WRENCH | GUARD |
| SCREWS |
BENT END OF
SILENCER GUARD
OPENING IN REAR
HOUSING
Fig. 4
7
